Step 1: permit the ground Heating "Drink Its Fill"
First, discover the water replenishment valve underneath the wall-hung boiler and gently open it as if you're twisting a mineral water bottle cap. you will hear the "gurgling" sound of water flowing, just like the ground heating is consuming. maintain a watch on the stress gauge; while the pointer slowly climbs to among 1-1.5bar, fast close the valve—do not allow it overdrink!
Step 2: Set the Temperature, manual the warmth
Press the "mode" button at the boiler to replace to "floor heating" mode. A small solar or radiator icon will seem at the screen, which is awesome lovely. Then press the "+" and "-" buttons to adjust the temperature. it's encouraged to set it to twenty℃ for the first use, letting the room heat up slowly like the arrival of spring.
Step 3: Wait Patiently, experience the warmth spread
while starting up first of all, the wall-hung boiler can also make a "whooshing" sound—it is running difficult! Be affected person; the floor heating warms up from the lowest up. After approximately 1-2 hours, you can step barefoot at the ground and feel the warmth growing from beneath your ft, as comfortable as stepping on clouds.
Little Reminder: keep the warmth Lasting
if you find a room is not heating up, there is probably small air bubbles causing problem. Open the air release valve on the manifold, let loose some "puffs" of air, and the warm temperature may be evenly distributed. don't forget to test the pressure gauge often; if it is under 1bar, add a few extra water to maintain the floor heating complete of electricity.
