Kitchen cabinets are susceptible to wooden rot due to lengthy-term publicity to water and oil fumes. There’s no want to replace them at once—repairing them step by step can shop money and extend the cabinet’s carrier existence, or even novices can do it～
I. Step 1: judge the Rot degree and decide the restore Plan
First, cautiously take a look at the rotten parts of the cabinet: if it’s handiest local mild rot (e.g., the edge of the cabinet door or the corner of the cabinet frame is moldy and gentle, without penetrating the board), handiest local treatment is needed; if the rot has penetrated the board, shaped holes, or the shape is unfastened (e.g., the drawer bottom is rotted via, the cupboard door is deformed and may’t near), the damaged parts want to be replaced. further, locate the motive of rot (e.g., leaking sink, cupboard door now not closed tightly leading to moisture), and clear up the basis hassle first (such as repairing sink gaps, changing growing old sealing strips) to prevent re-rot after restore.
II. Step 2: easy the Rotten parts and put off damaged materials
For moderate rot: Use sandpaper (80-grit coarse sandpaper) to sand the rotten region, grinding off the moldy and tender timber or board surface till the tough base fabric is uncovered; then wipe off the sanding dust with a dry material, and disinfect with an alcohol pad to save you mildew residue. If there's water accumulation in the rotten area, first absorb it with a water-absorbing fabric, then dry it with a hair dryer at the cold putting to make certain the repair vicinity is completely dry—otherwise, the following restore materials received’t stick firmly.
III. Step 3: repair or replace to repair cabinet characteristic
neighborhood restore (mild Rot): Fill the recessed vicinity after sanding with wood putty (pick oil-primarily based putty much like the cupboard shade for higher water resistance), smooth it with a scraper, and after the putty is completely dry (commonly 24 hours), sand it easy with 240-grit best sandpaper. finally, practice wooden paint of the same shade as the cupboard and allow it dry.
part substitute (excessive Rot): First measure the scale of the damaged part (e.g., drawer backside, cupboard door panel), and buy forums of the identical cloth (solid wood shelves choose timber of the identical tree species, panel shelves pick particleboard/multi-layer board of the identical thickness); use a screwdriver to dispose of the rotten part, cut the brand new board to the corresponding length, and attach it to the authentic body with wooden glue + screws, making sure it's far hooked up firmly and aligned with other parts.
IV. Step four: Do water-proof safety to keep away from Re-Rot
After restore, waterproof treatment is a need to: first, stick water-proof aluminum foil paper inside the cupboard underneath the sink and close to the range to isolate moisture and oil; 2nd, follow any other layer of water resistant timber paint to all timber parts of the cabinet (especially the repaired region) to beautify water resistance; 1/3, in daily use, wipe off water stains on the cabinet surface in time, regularly check if the sink and water pipes are leaking, and preserve the cabinet dry and ventilated to essentially save you rot.
